Bryant Plus 95S Evolution Troubleshooting (2024)

FAQs

How do I reset my Bryant evolution? ›

You have to reset the device by resetting the circuit breaker in your house. If not, you can simply browse for Bryant HVAC technicians near me and let them do it for you.

Follow These Steps To Reset Your Bryant Thermostat:

Locate the circuit breaker box and find the circuit breaker that is associated with your air conditioner unit. Then reset the circuit breaker for your air conditioner unit. Wait for 30 seconds to let the device calm down before turning the AC thermostat back on.

Check the circuit breakers at the electrical panel. Check the SSU switch (it looks like a light switch on a gray box located at the furnace) to be sure it is in the “ON” position. Check to ensure the furnace filter isn't in need of replacement. All one-inch thick furnace filters should be replaced monthly.

It's a small, red button usually located on or around the unit. The button should have a clear 'reset' label. Once you find the button, press it for around three seconds and observe the AC. Check whether the AC kicks on immediately and if it doesn't, press the button again for another three seconds.

If this is a Bryant or Carrier unit, the 95 error code is indicating that line voltage to the unit is over 257 volts ac.

The most common reason that air conditioners need a reset is that a circuit breaker was thrown as a safety mechanism. Your AC unit is designed with this safety feature to be activated in the event of a power outage to prevent fires or explosions.

The most common reason for an AC unit requiring a reset is when the protection circuit breaker in your AC unit kicks in. This typically happens after a power outage and is in place to prevent fires and explosions. A reset can also correct an AC that's only blowing warm air, even when the thermostat is set to “cool.”

Turn your thermostat “off”, then flip the related circuit breaker “off”. Wait 30 seconds, then turn the breaker back “on,” then the thermostat. Set the thermostat to hot or cold, whichever you prefer, and your desired temperature. This should effectively reset it.

A bad thermostat can be detected when your AC or furnace is not turning on, your HVAC systems are not turning off, the thermostat not responding, your HVAC system is short-cycling, the room temperature not matching the temperature displayed on the thermostat, and the programmed setting resetting themselves.

Why is my Bryant thermostat blank? ›

If your thermostat is blank, the first thing you should do is check the batteries. Chances are, the batteries have died and the thermostat simply can't power on. Replace the batteries and see if your thermostat turns on.

The thermostat may have a dead battery, so replace them with fresh ones and try again. Your furnace may turn on right away after this. If it doesn't, you may have a faulty power circuit. Have an HVAC professional diagnose this issue, and provide you with professional recommendations.

* On the Bryant Preferred series thermostat, the battery compartment is typically located on the back of the thermostat or behind the front cover. Some models may have a hinged front cover that you can open to access the batteries.

They are located just outside the burner chamber. Turn off the power then press the small button between the 2 leads to reset it. If it clicks you have reset it and the unit will fire up when you turn the power back on with any luck.

There is usually a small reset button somewhere on the thermostat. Finding this button may require that the thermostat panel be removed and pressing this button may require something like a paperclip to push. Hold the reset button down for 5 seconds and the thermostat should reset.